Scanning The Materials; Positioning The Materials - Microtek ObjectScan 1600 User Manual

Scanning the Materials

Positioning the Materials

1.
2.
Locate a handle at the front panel of the scanner. Grab it to pull out the
drawer of the scanner until reaching the edge of end.
If the height of a scanned object is less than 2.76" (7 cm), center the object
to be scanned facing up directly on the upper scan bed.
When placing the scanned object, do not block the calibration
Upper scan bed
Calibration area is next to the upper
scan bed.
ObjectScan 1600 User's Manual
area.
15