Power Led And Power Button - Dell Data Domain DD9500 Hardware Overview And Installation Manual

Figure 49 Power LED and power button
1. Power LED
2. Power button
5.
Note
The initial username is sysadmin and the initial password is the system serial
number.
Log into the Data Domain console using the sysadmin username.
localhost.localdomain login: sysadmin
6. Enter the default password, which is the system serial number (SSN). The SSN is
on the attached tag on the rear panel of the system. See the rear panel of the
DD9500/DD9800 system for the SSN tag.
Password: system_serial_number
Note
Configuring an HA pair sets the system password on the standby node to match
the system password on the active node, however, that synchronization is not set
until the HA configuration is complete. If the HA configuration fails, or if there is a
need to access either node before the HA configuration is complete, use the serial
number of each node as the password.
Note
If you enter an incorrect password four consecutive times, the system locks out the
specified username for 120 seconds. The login count and lockout period are
configurable and might be different on your system. See the Data Domain Operating
System Administration Guide and the Data Domain Operating System Command
Reference Guide for setting these values.
Configure System For Use
Enable administrative communication
87