Mount The Cable Management Assembly; Install The Data Domain Cable Management Assembly (Cma); Location Of Serial Number Tag - Dell Data Domain DD9500 Hardware Overview And Installation Manual

Mount the cable management assembly

Install the Data Domain cable management assembly (CMA)

7. Check the PSNT label at the rear of the chassis.
Figure 30 Location of serial number tag
8. Repeat these steps to install the second node.
A cable management assembly (CMA), for organization of cables at the rear of the
system, is already installed onto the DD9500/DD9800 system on a Data Domain rack.
For field installed systems, the CMA is shipped separately.
Note
For non-Data Domain racks, it is acceptable to use the cable management products
provided by the rack vendor.
Procedure
1. Take out the cable management assembly (CMA) from its packaging.
2. Locate the two blue knobs (on the left and right sides of the CMA) in the back
which you will need to pull away from the side of the CMA brackets to install
the CMA in the rack.
Install the System in the Rack
Mount the cable management assembly
47