Tools And Supplies Needed; Safety Information - Dell Data Domain DD9500 Hardware Overview And Installation Manual

Planning and Site Preparation

Tools and supplies needed

Safety information

Data Domain DD9500 and DD9800 Systems 6.1 Hardware Overview and Installation Guide
12
These tools and supplies may be helpful for the installation and setup tasks for Data
Domain systems.
Null modem cable (DB-9 female to female), plus spare
l
USB-to-DB-9 serial (male connector) converter cable if the laptop does not have a
l
serial port, plus spare
Power adapter, C13 to NEMA 5–15 (if based in North America), or a power cord
l
for your laptop power adapter with a C13 plug, so that you can power your laptop
from a rack PDU
Antistatic wrist strap and conductive foam pad
l
Screwdrivers:
l
Phillips #2 with a 12 in. or longer blade
n
Phillips #2 (standard-length blade)
n
Phillips #1
n
Flat head 3/16 in.
n
Flat head 1/4 in.
n
Torx T10
n
Flashlight
l
Needle nose pliers
l
Diagonal wire cutters (for cutting tie wraps)
l
2 GB or greater USB flash memory drive
l
Tie wraps (4 in. and 8 in.)
l
(recommended) Roll of 5/8 inch Velcro cable tie material (3M Scotchmate
l
SJ-3401 or similar)
CAUTION
If the system is used in a manner not specified by the manufacturer, the
l
protection provided by the equipment may be impaired.
The RJ45 sockets on the motherboard, PCI cards, or I/O modules are for
l
Ethernet connection only and must not be connected to a
telecommunications network.
Review this list of important safety recommendations.
All plug-in modules and blank plates are part of the fire enclosure and must be
l
removed only when a replacement can be added immediately. The system must
not be run without all parts in place.
A DD9500/DD9800 system must be operated only from a power supply input
l
voltage range of 200–240 VAC and 50–60 Hz. ES30 shelves use 100-240 VAC and
50–60 Hz. DS60 shelves use 200–240 VAC and 50–60 Hz.