Accepting The End User License Agreement; Power Led And Power Button - Dell DD9500 Manual

Figure 74. Power LED and power button
1. Power LED
2. Power button
5.
NOTE: The initial username is sysadmin and the initial password is the system serial number.
Log into the Data Domain console using the sysadmin username.
localhost.localdomain login: sysadmin
6. Enter the default password, which is the system serial number (SSN). The SSN is on the attached tag on the rear panel of
the system. See the rear panel of the DD9500 system for the SSN tag.
Password: system_serial_number
NOTE: Configuring an HA pair sets the system password on the standby node to match the system password on the
active node, however, that synchronization is not set until the HA configuration is complete. If the HA configuration
fails, or if there is a need to access either node before the HA configuration is complete, use the serial number of each
node as the password.
NOTE: If you enter an incorrect password four consecutive times, the system locks out the specified username for 120
seconds. The login count and lockout period are configurable and might be different on your system. See the Data Domain
Operating System Administration Guide and the Data Domain Operating System Command Reference Guide for setting
these values.
For Data Domain HA systems, SSH keys created on the active node take 30 seconds to one minute to propagate to the standby
node.

Accepting the End User License Agreement

The first time you log in to a Data Domain system, the End User License Agreement (EULA) is displayed.
At the end of the EULA, you are prompted to accept it:
Press any key then hit enter to acknowledge the receipt of EULA information
NOTE: The EULA must be accepted by a customer. A Data Domain representative should not accept this agreement. If a
customer is not present, press Ctrl-C to exit from the EULA acceptance screen and continue the installation.
Configure System for Use 81