Using The Cable Management System - Dell EQUALLOGIC PS6500 Hardware Manual

PS6500 Hardware Maintenance
2. Hold the chassis handles on the right side and the left side of the front panel and pull the chassis toward you,
exposing the disk drives.
To close and lock the chassis cover:
1. Slide the chassis completely into the rack.
Note: If the cover does not close completely, make sure the cam screws are turned counter-clockwise before
you slide the chassis into the rack.
2. Use a flathead screwdriver to turn the cam screws on the right side and left side of the front panel clockwise.
After you close and lock the chassis cover, you can install the bezel. See Removing and Installing the Bezel on
page 1-8.

Using the Cable Management System

The cable management system enables you to organize your power and network cables. It also enables you to open
the chassis cover without dislodging the cables.
Warning: For safety, you must use the cable management system to prevent pinching the cables and to reduce the
risk of electric shock.
The cable management system consists of two wire assemblies:
• One wire assembly has three arms, three clamps, and six fabric hook-and-loop fasteners.
• One wire assembly has one arm, two clamps, and three fabric hook-and-loop fasteners. See Figure 1-16.
1-10
Figure 1-15: Opening the Chassis
Basic Array Information