Connecting The Storage Enclosure To The Powervault Dl4000 System; Connecting The Cable Management Arm (Optional); Turning On The Dl Backup To Disk Appliance - Dell PowerVault DL4000 Deployment Manual
Backup to disk appliance - powered by appassure deployment guide
Hide thumbs
Also See for PowerVault DL4000:
- User manual (175 pages) ,
- Owner's manual (101 pages) ,
- Release note (11 pages)
Table of Contents
Advertisement
Figure 1. Setting the PowerVault MD1200 Storage Enclosure Configuration Switch
1. configuration switch
Connecting The Storage Enclosure To The PowerVault DL4000 System
Connect the data cable from the PowerEdge RAID Controller (PERC) installed in the PowerVault DL4000 system to the
primary Enclosure Management Module (EMM) SAS In port of the storage enclosure. For more information, see the
figure below.
Figure 2. Connecting the SAS Cable From the PowerVault DL4000 System to the PowerVault MD1200 Storage Enclosure
Connecting The Cable Management Arm (Optional)
If the appliance includes a cable management arm (CMA), locate the CMA
CMA kit and follow the instructions to install the CMA.
Turning On The DL Backup To Disk Appliance
After cabling the appliance, turn on the MD1200 storage enclosure, and then turn on the PowerVault DL4000 system.
NOTE: It is recommended that you connect the appliance to an uninterrupted power supply (UPS) for maximum
reliability and availability. For more information, see your system's
Installation Instructions that shipped with the
Owner's Manual at dell.com/support/manuals.
7
Advertisement
Table of Contents
