Setting The 802.1P Priority For Mld Messages - HP FlexFabric 5700 Series Configuration Manual

You can also change the source IPv6 address of MLD reports or leave messages sent by a simulated
member host.
To configure the source IP addresses for MLD messages in a VLAN:
Step
1. Enter system view.
2. Enter VLAN view.
3. Configure the source IPv6
address for MLD general
queries.
4. Configure the source IPv6
address for MLD
multicast-address-specific
queries.
5. Configure the source IPv6
address for MLD reports.
6. Configure the source IPv6
address for MLD done
messages.

Setting the 802.1p priority for MLD messages

When congestion occurs on outgoing ports of the Layer 2 device, it forwards MLD messages in their
802.1p priority order, from highest to lowest. You can assign a higher 802.1p priority to MLD messages
that are created or forwarded by the device.
You can configure the 802.1p priority of MLD messages for all VLANs in MLD-snooping view or for the
current VLAN in VLAN view. The configuration made in VLAN view takes priority over the configuration
made in MLD-snooping view.
Command
system-view
vlan vlan-id
mld-snooping general-query
source-ip { ipv6-address |
current-interface }
mld-snooping special-query
source-ip { ipv6-address |
current-interface }
mld-snooping report source-ip
ipv6-address
mld-snooping done source-ip
ipv6-address
72
Remarks
N/A
N/A
The default setting is the IPv6
link-local address of the current
VLAN interface. If the current
VLAN interface does not have an
IPv6 link-local address, the source
IPv6 address is
FE80::02FF:FFFF:FE00:0001.
By default, if the MLD snooping
querier has received MLD general
queries, the source IPv6 address of
MLD multicast-address-specific
queries is the source IPv6 address
of MLD general queries.
Otherwise, it is the IPv6 link-local
address of the current VLAN
interface. If the current VLAN
interface does not have an IPv6
link-local address, the source IPv6
address is
FE80::02FF:FFFF:FE00:0001.
The default setting is the IPv6
address of the current VLAN
interface. If the current VLAN
interface does not have an IPv6
address, the source IPv6 address is
FE80::02FF:FFFF:FE00:0001.
The default setting is the IPv6
address of the current VLAN
interface. If the current VLAN
interface does not have an IPv6
address, the source IPv6 address is
FE80::02FF:FFFF:FE00:0001.