You can configure parameters for IGMP queries and responses for the current VLAN in VLAN view or
globally for all VLANs in IGMP-snooping view. The configuration made in VLAN view takes priority over
the configuration made in IGMP-snooping view.
Configuring the global parameters for IGMP queries and responses
Step
1.
Enter system view.
Enter IGMP-snooping view.
2.
3.
Set the maximum response
time for IGMP general
queries.
4.
Set the IGMP last member
query interval.
Configuring the parameters for IGMP queries and responses in a VLAN
Step
1.
Enter system view.
2.
Enter VLAN view.
3.
Set the IGMP general query
interval in the VLAN.
4.
Set the maximum response
time for IGMP general queries
in the VLAN.
5.
Set the IGMP last member
query interval in the VLAN.
Configuring parameters for IGMP messages
This section describes how to configure parameters for IGMP messages.
Configuration prerequisites
Before you configure parameters for IGMP messages in a VLAN, complete the following tasks:
•
Enable IGMP snooping for the VLAN.
Determine the source IP address of IGMP general queries.
•
Determine the source IP address of IGMP group-specific queries.
•
•
Determine the source IP address of IGMP reports.
Determine the source IP address of IGMP leave messages.
•
Determine the 802.1p priority of IGMP messages.
•
Command
system-view
igmp-snooping
max-response-time interval
last-member-query-interval interval
Command
system-view
vlan vlan-id
igmp-snooping query-interval interval
igmp-snooping max-response-time
interval
igmp-snooping
last-member-query-interval interval
25
Remarks
N/A
N/A
The default setting is 10
seconds.
The default setting is 1
second.
Remarks
N/A
N/A
The default setting is 125
seconds.
The default setting is 10
seconds.
The default setting is 1
second.