Setting The Source Delay - YOKOGAWA GS820 User Manual

5.5

Setting the Source Delay

Procedure
Explanation
5-10
1.
Press CONFIG in the SOURCE section of the front panel to display the CONFIG
menu.
2.
Press the S.Delay soft key to display the source delay setup screen.
3.
Use the rotary knob or numeric keys&< > to set the source delay.
If you use the numeric keys, press the soft key for the desired unit to confirm the
setting.
Source Delay
A wait time from when the trigger is generated until the source operation is started. Set
the source delay to adjust the phase difference between channels when synchronizing
multiple channels or to correct the timing of the external trigger signal.
Selectable Range
15 µs to 3600.000000 s
Relationship between the Source Operation and Source Delay
If Sweep is OFF (DC Source Mode)
The source delay is not used. The setting changes when you change the setting from the
panel keys or communication command.
Source
Next source level
Previous source
level
↑
Setting change
Time
IM 765601-01E