General Operating Instructions; Power On; Standby - Tesla 32K307BH Operating Instruction

ENG
Remote control user manual about teletext
TeleText: Press ''Teletext'' key, it loops in 3 modes: Mix Display > Text Mode > TeleText Off.
Thereinto: TText Mode is Automatic Mode. In Automatic mode, the system automatically selects TOP, Fastext, or Default
mode as appropriate, depending on the data being received. In Text Mode or Mix Display, press number 0~9, "/''
key to select text page.
Reveal: All hidden characters are displayed for 6 seconds.
Hold: Toggle hold on or off for current display pages. If the page is not held, it will become held, which will prevent its
update. If the page is currently held, the hold will be removed thus allowing the page to update. When the page is held,
this is indicated by a Hold prompt.
Index: In Fastext mode, request the index page if the index link is valid, or the Packet 8/30 initial page if valid, or page
100. In TOP mode, if the Hitlist option is enabled, toggle the system between the current text page and the Hitlist menu;
otherwise, request page 100. In List mode, reset the list of preferred pages either to that of the current channel as read
from the EEPROM if fitted, or to the default list (pages 100, 101, 102, 899), and request the first page in the list. In Default
mode, request the Packet 8/30 initial page if valid, or page 100.
List: Toggle between L ist mode and the current acquisition mode (Fastext, TOP, or Default).
Red, Green, Yellow, Blue: Request the associated page in the display block according to the acquisition mode. In TOP
Hitlist mode, the Red, Green, and Blue commands control selections from the Hitlist menu, while the Yellow command is
ignored.

General Operating Instructions

Before switching on the device, please make sure that the power supply is stable and that the antenna cable is well
connected.

Power On

English Portuguese
French
Spanish
Plug the power cord into electrical socket. Press " " key on the remote control or on the TV set to turn on the TV. ''Please
select an OSD Language'' menu (Fig.1) is displayed on the screen. Press "//t/u'' key on the remote control to
select desired language, then press "OK" key on the remote control to confirm. "Select DVB type''is displayed on
the screen. Press "/" key on the remote control to select desired DVB type, then press "OK" key to continue to
the next step (Fig.2). (The provided example shows channel searching DVB type under DVB-T.) Press "t/u" key to
select Tune Type: DTV + ATV, ATV, DTV. Press "" key. You can select country where you are by pressing "//t/u",
then press "OK" key to confirm.The device will initiate auto tuning.

Standby

Press " " key on the remote control, TV will be in standby.
Special Attention:
1. The TV set will automatically switch to standby if there is no signal input for 5 minutes after switching the TV on.
2. The TV set will automatically switch to standby when the preset time for turning off is reached.
3. If you do not use it for a long time, please turn off the power supply of the device. Do not let the device work
in standby state for a long time.
Please select an OSD Language
Polish Croatian
German Dutch Arabic
Italian Russian Farsi
OK: Enter
Fig. 1
Tune Type
Germany
Greece
Hungary
Luxembourg
MENU: Return
10
DTV + ATV
Italy Netherlands
Ireland
Norway
Poland
Fig. 2