Water System; Changing The Filter Bag (Cerec Suction Device) - DENTSPLY CEREC MC X Cleaning And Maintenance

Water System

Change the water at least once a week or when prompted by the system after
240 minutes wet machining time.
• Add 75ml Dentatec to the tank
• Fill the tank with water until the filter(s) is/are completely immersed
(up to the bottom edge of the cover thread, approx. 3 liters)
Clean the filter(s) when changing the water or when the "water pressure too
low" message appears. Remove the filter(s) from tank and hold under warm
water while washing out material.
Change the filter(s) immediately if damaged; otherwise every 3 months or
after 3-4 filter cleanings.
Clean the cooling water jets if they do not strike the machining instruments by
carefully removing any foreign particles from the water nozzles with a cleaning
wire or probe. This will help to extend the life of the instruments.

Changing the Filter Bag (CEREC Suction Device)

If there is a significant fall in suction power when dry milling zirconia, the filter
bag (REF 65 78 095) could be full and will need replacing. Typically a filter
bag should offer capacity for ca. 120 restoration units. This number can vary
depending on the amount of zirconia material milled and extracted. To change
the filter bag:
1. Loosen and remove the two knurled nuts on the maintenance cover.
2. Remove the cover.
3. Remove the full bag from the nozzle and replace with a new one.
4. Place the cover back on and screw tighten the two knurled nuts.
Note: ensure that the cap is sealed properly and the filter bag is not jammed.
1 Removing the cover
04
2
Replacing the filter bag