Table of Contents
Advertisement
Step 1
Step 2
Step 3
Front Panel Indicators
STATUS
78-19034-01
Connect the earthing cable as described in the "Caution" in
Connect the mains power cable.
Install the Cisco VG30D Voice Gateway in a place that is near the mains
Note
power socket-outlet. Install the Cisco VG30D Voice Gateway in a place
from which you can reach the mains outlet easily.
Connect the 10/100 Ethernet cable.
The Cisco VG30D Voice Gateway unit includes 10 LEDs on its front panel. They
show unit status information.
Figure 3
shows.
Figure 3
Front View
The four red STATUS LEDs are labelled S3, S2, S1 and S0. They indicate unit
status in conjunction with the two port LEDs, P1 and P2. During unit self-test, the
status LEDs will come on and go off in sequence, and, in the event of a self-test
failure, stop with one LED remaining on.
This section describes the front panel indicators that
Port Active
LEDs
STATUS
LAN
P1
P2
Power
Status of
Local Area
active port
Network
LEDs
LEDs
Cisco VG30D Voice Gateway Quick Start Guide
Front Panel Indicators
Hardware
Installation.
Cisco VG30D
Power LED
(Amber in self
test, Green when
operational)
5
Advertisement
Table of Contents
