Self-Test Failure; Warranty Terms - Cisco VG30D Quick Start Manual

Warranty Terms

Self-Test Failure

Warranty Terms
Cisco VG30D Voice Gateway Quick Start Guide
10
The set parameters will get used the next time that the Cisco VG30D
Note
Voice Gateway is re-booted, but the Cisco VG30D Voice Gateway will
remain accessible through the active connection until then.
The Cisco VG30D Voice Gateway may now be powered OFF, and installed and
connected to the IP network (accessible through the new IP address), or you may
continue with further configuration by using the Gateway Management Interface
as described in Sections 3 and 4 of the Cisco VG30D Voice Gateway User Guide.
If any test in the sequence fails, the cycle of the STATUS LEDs will stop (with
one LED remaining on) and the Power LED will remain AMBER.
You can obtain details of any failures if the unit undergoes the self-test when
connected from the Craft Port to a dumb terminal or a terminal emulation
application on a computer that is running RS-232 at 9600 baud, 8 bit, 1 stop bit
and no parity or flow control.
If an error is reported, consult the "Fault Determination" section in the
Cisco VG30D Voice Gateway User Guide for the appropriate corrective action or
call your support contact. After errors have been corrected, make sure that the
self-test runs satisfactorily to completion and proceed as described in the
Successful Self-Test section.
The following are special terms applicable to your hardware warranty.
Duration of Hardware Warranty: One (1) Year
Replacement, Repair or Refund Procedure for Hardware: Cisco or its service
center will use commercially reasonable efforts to ship a replacement part within
ten (10) working days after receipt of the RMA request. Actual delivery times
may vary depending on Customer location.
78-19034-01