Table of Contents
Advertisement
No other use is permitted (e.g.
heating rooms).
INSTALLATION
The appliance must be handled and
installed by two or more persons. Use
protective gloves to unpack and
install the appliance.
Installation and repairs must be
carried out by a qualified technician,
in compliance with the
manufacturer's instructions and local
safety regulations. Do not repair or
replace any part of the appliance
unless specifically stated in the user
manual.
Children should not perform
installation operations. Keep children
away during installation. Keep the
packaging materials (plastic bags,
polystyrene parts, etc.) out of the
reach of children, during and after
the installation.
After unpacking the appliance, make
sure that it has not been damaged in
transit. In the event of problems,
contact the dealer or your nearest
After-Sales Service.
The appliance must be disconnected
from the power supply before any
installation operation.
During installation, make sure the
appliance does not damage the
power cable.
Only activate the appliance when the
installation has been completed.
After installation, the bottom of the
appliance must no longer be
accessible.
Carry out all cabinet cutting works
before fitting the appliance in the
furniture and carefully remove all
wood chips and sawdust.
Do not obstruct the minimum gap
between the worktop and the upper
edge of the oven.
Only remove the oven from its
polystyrene foam base at the time of
installation.
Do not install the appliance behind a
decorative door – risk of fire.
ELECTRICAL WARNINGS
For installation to comply with
current safety regulations, an
omnipolar switch with minimum
contact gap of 3 mm is required and
the appliance must be earthed.
If the power cable is damaged,
replace with an identical one. The
power cable must only be replaced
by a qualified technician in
compliance with the manufacturer's
instructions and current safety
regulations. Contact an authorised
After-Sales Service.
It must be possible to disconnect the
appliance from the power supply by
unplugging it if the plug is accessible,
or by means of an accessible multi-
pole switch installed upstream of the
socket in conformity with national
electrical safety standards.
The rating plate is on the front edge
of the oven (visible when the door is
open).
In case of replacement of the power
cable, contact an authorised service
centre.
If the fitted plug is not suitable for
your socket outlet, contact a qualified
technician.
The power cable must be long
enough to connect the appliance,
once fitted in its housing, to the main
power supply. Do not pull the power
supply cable.
6
Advertisement
Table of Contents
