Fitting The Appliance; Prior To Connecting; After Connecting; Before First Use - KitchenAid KOQCX 45600 Instructions For Use Manual

Fitting the appliance

Follow the separate fitting instructions supplied
when installing the appliance.

Prior to connecting

Check that the voltage on the rating plate
corresponds to the voltage in the home.
Ensure that the appliance oven cavity is empty
before fitting.
Ensure that the appliance is not damaged. Check that
the microwave oven door closes firmly against the door
support and that the internal door seal is not damaged.
Empty the appliance oven and clean the interior with a
soft, damp cloth.
Do not operate this appliance if it has a damaged
mains cord, if it is not working properly, or if it has
been damaged or dropped. Do not immerse the
mains cord in water. Keep the cord away from hot
surfaces.

After connecting

The appliance can be operated only if the
appliance oven door is firmly closed.
The earthing of this appliance is compulsory. The
manufacturer accepts no liability for injury to persons,
animals or damage to objects arising from the failure to
observe this requirement.

Before first use

1. O , remove the accessories and
PEN THE DOOR
ensure that the oven is empty. R
with tap water (no detergents) and
CONTAINER
then fill it to the "MAX" mark.
S
LIDE THE WATER CONTAINER
engages in the contact point and sits firmly in
place.
2. R
UN THE CALIBRATION FUNCTION
screen instructions.
N
OTE
T responsible for filling and draining
HE WATER PUMP
the steam boiler is now activated. It will initially
sound louder while it is pumping air, and quieter
when water is filling the pump again.
INSE THE WATER
into its socket until it
and follow on-
If the power cable is too short or damaged, it
must be replaced. The power cable must only be
replaced by a qualified technician in compliance
with the manufacturer's instructions and current
safety regulations. Contact an authorised After-
Sales Service.
For installation to comply with current safety
regulations, an omnipolar disconnect switch with
minimum contact gap of 3 mm must be used.
The manufacturers are not liable for any problems
caused by the user's failure to observe these
instructions.
T , and no reason for alarm.
HIS IS NORMAL
A
FTER CALIBRATION
temperature and then wipe dry any damp
areas if present.
E
MPTY THE WATER CONTAINER
further use.
9
, let the oven cool to room
and dry it off before