Canon H1 Service Manual page 84

5
Adjustment > When replacing parts (Reader)
3) Enter the service mode, and then select the following:
(Lv.1) COPIER> FUNCTION> INSTALL> STRD-POS CCD (stream reading position
adjustment)
4) Adjust tray width. Perform either AB system or Inch system.
a. AB system adjustment
1) Adjust the slide guide to the index "A4/A3".
2) Select the item in the service mode.
(Lv.1) FEEDER > FUNCTION > TRY-A4
3) Press OK, and register the A4 width.
4) Adjust the slide guide to the index "A5R".
5) Select the item in the service mode.
(Lv.1) FEEDER > FUNCTION > TRY- A5R
6) Press OK, and register the A5R width.
b. Inch system adjustment
1) Adjust the slide guide to the index "LTR/11x17".
2) Select the item in the service mode.
(Lv.1) FEEDER > FUNCTION > TRY-LTR
3) Press OK, and register the LTR width.
4) Adjust the slide guide to the index "STMT/LTRR/LGL".
5) Select the item in the service mode.
(Lv.1) FEEDER > FUNCTION > TRY- LTRR
6) Press OK, and register the LTRR width.
5) Finalize the setting in the following service mode.
(Lv.1) COPIER> ADJUST> CCD> CCD-CHNG> 1 (Data at factory shipment is not used)
6) Make an output of P-PRINT.
(Lv.1) COPIER > FUNCTION > MISC-P > P-PRINT
7) Store the outputted P-PRINT into the service book.
8) After turning OFF/ON the power, make a copy and check the copied image.
5 Adjustment > When replacing parts (Reader)
5-5
5-5