Check The Height Of The Left Hinge; Check The Height Of The Right Hinge - Canon H1 Service Manual

5
Adjustment > Adjustment Method (DADF) > Adjusting the Height of the hinge > Check the height of the right hinge

■ Check the height of the left hinge

1) Checking the rear-left height of the DADF.
Cut a sheet of A4 paper(use plain paper) to make a paper slip with width of 45mm.
Set paper against the protrusions of the stream reading glass in such a manner that the
seat of the stream reading glass is nearly hidden.
CAUTION:
Set paper so that it does not reach the document reader.
NOTE:
By placing the paper slip as instructed, it does not interfere the soundproofing sheet
stuck on the bottom of the DADF when closing it.
2) Pulling out the set paper
Pull out the paper in the direction of the arrow to check that you feel slight resistance.
5 Adjustment > Adjustment Method (DADF) > Adjusting the Height of the hinge > Check the height of the right hinge
Paper
F-5-5
F-5-6
3) Checking the front-left height of the DADF.
Set paper against the protrusions of the stream reading glass in such a manner that the
seat of the stream reading glass is nearly hidden.
CAUTION:
Set paper so that it does not reach the document reader.
4) Pulling out the set paper.
Pull out the paper in the direction of the arrow to check that you feel slight resistance.

■ Check the height of the right hinge

1) When the DADF is closed, the document hold sheet must be in contact with the document
glass.
5-8
Paper
F-5-7
F-5-8
5-8