•
Last Selected – when changing modes the radio enters the DMO Talkgroup last selected,
i.e. the DMO Talk Group active last time the Radio was in DMO Mode. If Group Mappings
are configured, they will take precedence and the DMO Talkgroup mapped to the current
TMO Talkgroup is used.
•
Group Mappings – when changing modes the radio enters the DMO Home Group unless a
Group Mapping is configured. If Group Mappings are configured, they will take precedence
and the DMO Talkgroup mapped to the current TMO Talkgroup is used.
•
Home Group – when changing modes the radio enters the DMO Home Group, ignoring
possible group mappings.
6 Select TMO Home Group – configures the TMO Home Group/Home Folder.
7 Select DMO Home Group – configures the DMO Home Group.
4.8.1.1
Standard Home Group
This menu item allows you to configure the standard home group to be used during start up and when
changing modes: TMO → DMO and TMO → Repeater.
4.8.2
Scan
This menu item allows you to activate/deactivate scanning, view the active scan list, and edit the scan
lists. This feature is available only for the TMO Mode. Your radio joins any group call as long as this
group is defined in the scan list and scan is turned on.
4.8.2.1
Activating Talkgroup Scanning
When and where to use: If you want to monitor any TMO Group Call in the defined talkgroup list.
Procedure:
1 From the home screen, press the Menu key.
2 Select Group Setup → Scan → Scanning.
3 Select Select List and then a list name.
Your radio displays list name selected.
4 Select Scanning → On.
Your radio is scanning on the predefined scan list.
4.8.2.2
Setting Talkgroups in the Active Scan List
When and where to use: If you want to edit talkgroups in the active scan list.
Procedure:
1 From the home screen, press the Menu key.
2 Select Group Setup → Scan → Active List.
NOTICE: If Scanning is Off is displayed, go to Group Setup → Scan → Scanning
→ On to enable scanning.
3 Select View and highlight the required talkgroup.
Send Feedback
68015000897–FC
Chapter 4: Main Menu
91