Sending An Rms Status; Additional Address; Enabling Or Disabling Additional Address - Motorola MTP3100 User Manual

68015000897–FC
Chapter 4: Main Menu
•
Status Sent.
•
Status Failed.
4.3.10

Sending an RMS Status

Prerequisites: This feature is only available when enabled by your service provider. See
Messaging System (RMS) on page 109
Procedure:
1 Do one of the following:
• From the home screen, press Menu → Messages → Send RMS/FMS.
• Press and hold the One Touch Button configured to display the Send RMS/FMS menu.
NOTICE: The navigation through the radio menu is only available if your service provider
enabled the Send RMS/FMS menu item. However, your service provider can configure a
One Touch Button to display the Send RMS/FMS menu even if the navigation is not
possible.
If the Send RMS/FMS menu item is disabled, and no One Touch Button is configured to
display the Send RMS/FMS menu, then the radio can only receive RMS messages but
cannot send them.
2 Scroll to the required RMS status.
4.3.11

Additional Address

The Additional Address feature allows the radio to send RMS messages, and Local Information
Protocol (LIP) reports to additionally defined recipients.
The default addresses where the radio sends RMS messages and LIP reports are defined by your
service provider. If an Additional Address is selected and enabled, RMS messages and LIP reports are
also sent to the recipient defined in the Additional Address.
You can create, edit, and delete Additional Addresses using the radio menu. If an Additional Address is
configured by your service provider, the service provider can disable edition and deletion of the
address using the radio menu.
You can define up to 30 Additional Addresses.
4.3.11.1

Enabling or Disabling Additional Address

Procedure:
1 From the home screen, press the Menu key.
2 Select Messages → Additional Address → Enable.
3 Select one of the following:
• On – to activate the feature
• Off – to deactivate the feature
64
for details.
Radio
Send Feedback