Overview - PSC PT2000 User Manual

Programming the PT2000 and TopGun

Overview

58
PT2000 and TopGun recognize the following commands at all times:
Sets the portable to alpha mode
*/+*
Sets the portable to normal mode
*/-*
Has the same effect as the
*--*
Has the same effect as the
*-+*
Prepares the portable to accept a program
*/.*
Sounds a low beep on the portable
*.-*
Sounds a high beep on the portable
*.+*
Clears all memory and resets the portable
*+.*
Retrieves data if the application program stops execution
and gives the
*$$*
portable to the PC and start the communications program,
then scan this bar code. The data will transmit, one file at a
time.
Enter these commands with bar codes or through the PC's serial port.
With PSC Program Generator (PPG), it is possible to embed these
codes in a PPG program. For information about using PPG to program
the portable, refer to the PSC Program Generator User Manual.
<Clear>
<BKSP>
PROGRAM FAILED
PT2000™ & TopGun™
key
(backspace) key
message. Connect the