Calibrating From The Control Panel Using Autocal2 - Canon ColorPASS-Z5000 Color Manual

3

3-35 Calibrating from the Control Panel using AutoCal2

Calibrating from the Control Panel using AutoCal2
You can calibrate the ColorPASS from the Control Panel using AutoCal2, which
calibrates the ColorPASS using the copier's built-in scanner as a densitometer. If an
Administrator password has been set, you will need it for calibration.
For instructions on using the ColorPASS Control Panel, see the Configuration Guide.
For troubleshooting during the AutoCal2 procedure, see the Job Management Guide.
To calibrate using AutoCal2, you will need the Kodak Gray Scale strip included
N :
OTE
in the customer media pack that came with your ColorPASS.
T A
O ACCESS AND USE UTO
1. At the Idle screen, press the Menu button to enter the Functions menu.
2. Choose Calibration, and choose Set Up Calibration.
If a password is set on the ColorPASS, enter it and press OK.
3. For Calibration Mode, select Standard or Expert.
Expert Mode adds the option to print a Comparison Page (see page 3-33).
4. For Tray, choose the paper source for the patch page and press OK.
Select LTR/A4 from the ColorPASS Control Panel.
If you print a measurement page from the Stack Bypass tray, you must load the
N :
OTE
appropriate paper in the Stack Bypass tray and select the correct paper size from the
copier touch panel display.
5. Choose Calibrate.
6. Select the calibration set.
You can choose from the list of all calibration sets on the ColorPASS. This screen
appears only if more than one calibration set is available.
C 2:
AL