Lantronix XPress DR User Manual page 65

Command
AT
TT
NC
RS
QU
G0, G1, ....,Ge,
Gf
S0, S1,...,Se,
Sf
R0, R1, ....,Rb,
Rc
W0, W1, ....,Wb,
Wc
GM
SS
SA
NS
co
VN
Responses to some of the commands are given in Intel Hex format (see
Note: You may be required to enter QU twice to exit monitor mode.
XPress™ DR Industrial Device Server User Guide
Command Name
ARP Table
TCP Connection Table
Network Connection
Reset
Quit
Get configuration from
memory page
Set configuration to
memory page
Get configuration from
memory page
Set configuration to
memory page
Get MAC address
Set Security record
Scan
Network Status
Set IP address, host
bits, gateway, and
DNS server IP
Query full firmware
version
Function
Shows the unit's ARP table entries.
Shows all incoming and outgoing TCP connections.
Shows the unit's current IP address, gateway, subnet
mask, and DNS server.
Resets the unit's power.
Exits diagnostics mode.
Gets a memory page of configuration information from
the device for setup record 0 to15.
Sets a memory page of configuration information on the
device for setup record 0 to15.
Gets a memory page of configuration information from
the device for setup record 16 to28.
Sets a memory page of configuration information on the
device for setup record 16 to 28.
Shows the unit's 6-byte MAC address.
Sets the Security record without the encryption key and
length parameters. The entire record must still be
written, but the encryption-specific bytes do not need to
be provided (they can be null since they are not
overwritten).
Initiates a wireless scan if the wireless interface is
enabled. Reports any stations found, including BSSID,
SSID, and RSSI. If SA is followed by a string, the string
is used to filter SSIDs before reporting. If the BSS does
not broadcast its SSID, only the BSSID and RSSI are
returned.
Reports the network interfaces' statuses. Includes
potentially negotiated parameters like speed/duplex for
Ethernet or BSSID, encryption, authentication for
wireless interfaces.
Example:
co 192.168.0.10 8 192.168.0.1 10001 192.168.1.10
with
192.168.0.10 = IP address of the XPress DR
8 = number of host bits
192.168.0.1 = gateway IP address
10001 = port number of the XPress DR
192.168.1.10 = IP address of the DNS Server
The XPress DR stores the setup and performs a reset.
It sends an X before the reset if the command was OK.
This command queries and displays full firmware
version in readable string format.
11: Monitor Mode
The Intel Hex Format).
65