Table of Contents
Advertisement
Command
RDS?
NET?
REV?
PILOT?
AF?
AF.CLEAR
SNTP.SYNC
ISDST?
RESET
GRMON?
GRMONINI
UPTIME?
RESET
INIT
CLS
Response
OK
NO
ACCESS DENIED Command is disabled for this port by Access Rights
DON'T FORGET
entered or changed easily through either the Windows
SPECIAL COMMANDS
Description
Returns all data in encoder memory
Returns all Network settings
Returns firmware & hardware revision numbers
Returns the Status of the 19 kHz PLL.
LOCK - locked to the 19kHz stereo pilot signal.
NOLOCK - defaulted to the internal timebase
Returns the current AF list
Clears the current AF list
Forces SNTP to synchronize immediately
DST is in effect? (1 = DST is observed, 0 = DST is not observed)
Resets the encoder as if AC power were cycled off and on
RDS groups counters
Clears the RDS groups counters
Returns device uptime
Resets the encoder as if AC power were cycled off and on
Initializes the encoder to all factory defaults
Clears the Terminal Screen
Meaning
Command received by encoder properly formatted and understood
Command properly formatted but data not understood
that all the static RDS registers, including simple scrolling messages, can be
- 42 -
65 Aleksandar Stamboliyski Str., 8000 Bourgas, Bulgaria
Tel: +359 56 820027, Fax: +359 56 836700
E-mail: office@devabroadcast.com ,Web: www.devabroadcast.com
or network data entry screens.
®
Advertisement
Table of Contents
