Table of Contents
Advertisement
SmartGen Mini can be accessed through Internet using your favorite browser. No additional
software is required.
To access Device Web Interface it is necessary to know what IP address is assigned to device.
(see "Network Settings" on page 39)
Into browser's address field type device IP, e.g. http://192.168.20.16. Depending on browser it
may be required to specify port, which is appended after IP address and in our default case must
be :80.
ATTENTION: Depending on Internet Protocol Settings, assigned IP address may not be visible
outside your local network, thus device may be accessed only within that network. Consult with
your network administrator for the appropriate IP settings.
Username and Password will be requested when connecting for the first time. Default values
are user and pass.
The WEB interface is visually divided into two sections:
1. On top of the control window is placed constant section containing all the mandatory
settings and statuses. This section is intended to allow fast reading of these parameters and
is a permanent part of the WEB Interface.
2. Below this section is placed the content of each tab that enables the set-up of the RDS/
RBDS encoder - Basic RDS, AF List/Group Sequence, Monitor.
E-mail: office@devabroadcast.com ,Web: www.devabroadcast.com
WEB Configuration
and device password.
- 45 -
65 Aleksandar Stamboliyski Str., 8000 Bourgas, Bulgaria
Tel: +359 56 820027, Fax: +359 56 836700
Advertisement
Table of Contents
