I/O Module Status Indicators - Promise Technology VTrak J310S Product Manual

LEDs
Power/Activity*
Status
* Refers to SAS drives or SATA drives with an AAMUX adapter.
For SATA drives without an AAMUX adapter, LED behavior depends on
the specific disk drive.
** Refer to the user documentation for your HBA or RAID controller for this
information.

I/O Module Status Indicators

The VTrak J610s or J310s I/O module has LEDs that indicate activity on each of
its SAS ports.
Figure 3. The I/O modules have two SAS ports
Circle-icon port (CN1) LED
I/O Module Status LED
The I/O module status LED shows red at startup. Within 2 or 3 seconds, it turns
green to indicate that the I/O module is ready.
LEDs
Connectors
I/O Module
Status
* Turns green 2 to 3 seconds after subsystem startup.
Dark
No Drive
HBA/RAID controller determines the LED behavior**
Diamond-icon port (CN2) LED
Dark
Link Down Link Up
Off Ready
33
State
Steady Green
Drive Present
State
Steady Flashing
Green Green
Activity
Chapter 3: Management
Flashing Green
Activity
115200
8 N 1
Red
Starting up*