Operating Procedures
CX-FLnet Operating
Procedure
Make settings in CPU Bus Unit Setup Area.
Make local node settings.
Make other node settings.
System settings: Make expansion settings
(data transfer sequence) when required.
Turn PLC power ON or restart the FL-net Unit.
Begin FL-net Unit operation.
Confirm that operation is normal, and then save
Note
11-2 Operating Procedures
11-2-1 Starting
1,2,3...
1,2,3...
170
CX-FLnet installation (Setup will also be performed if CX-One is installed.)
Make communications settings.
↓Unit settings
System settings
↓
System settings
↓
System settings
↓
↓
Transfer settings.
↓
↓
↓
the settings.
↓
Exit the CX-FLnet.
1. The new settings go into effect when the PLC's power is turned ON again
or when the FL-net Unit is restarted.
2. Confirm that the communications settings are correct for the environment
in which they are to be used.
There are two methods of starting CX-FLnet.
Starting from the Start Menu
1. Click the Start Button.
2. Select Program - OMRON - CX-One - CX-FLnet.
Starting from the CX-Programmer
1. Click the I/O tables in the Project Workspace Window in the CX-Program-
mer.
2. Add an FL-net Unit to the I/O tables. (If the CX-Programmer is online to the
PLC, transfer the I/O tables from the PLC to the computer.)
3. Right-click the FL-net Unit and select Start Special Application from the
pop-up menu.
Section 11-2
↓Monitoring
Select monitor function.
↓
Display monitor screens.
↓
Click the Update Button
to update the display if required.
↓
Check display contents.
↓
Close monitor screens.
↓
Exit the CX-FLnet.