Page 1
QVSP Operator’s Manual Image shown with optional accessories Owner's Manual QV550HSP, QV900HSP Accessories Debris bags and Filter VACUUM HOSE DEBRIS BAG PARKING STANDARD DEBRIS AND HOOD FILTER SKIRT BRAKE DEBRIS BAG DUST SOCK 5" (127mm) x 10' Directs dust Locks the...
Page 2
QVSP Operator’s Manual CONTENTS SPECIFICATIONS AND SOUND/VIBRATION ___ _____ INSTRUCTION LABELS PACKING CHECKLIST AND ASSEMBLY ______ OPERATION AND BAG CARE _6-7 MAINTENANCE AND TROUBLESHOOTING ______8-9 ILLUSTRATED PARTS & PART LISTS 10-14 MAINTENANCE RECORD________________________________________________15 Part No 831500 Form No F052912A...
INSTRUCTION LABELS ® The labels shown below were installed on your BILLY GOAT QVSP Vacuum. If any labels are damaged or missing, replace them before operating this equipment. Item numbers from the Illustrated Parts List and part numbers are provided for convenience in ordering replacement labels.
Page 5
QVSP Operator’s Manual PACKING CHECKLIST Your Billy Goat is shipped from the factory in one carton, completely assembled except for the nozzle. READ all safety instructions before assembling unit. TAKE CAUTION when removing the unit from the box PUT OIL IN ENGINE BEFORE STARTING PARTS BAG &...
Page 6
QVSP Operator’s Manual OPERATION VACUUMING OPERATION VACUUM NOZZLE HEIGHT ADJUSTMENT: Is adjusted by turning the knob clockwise increases height and counter-clockwise to lower it. Adjust nozzle height according to surface conditions and debris size; For vacuuming on flat surfaces, set nozzle 1/2" (12.7 mm) to 5/8"...
Page 7
QVSP Operator’s Manual DUST SOCK CARE AND MAINTENANCE Purpose: The dust sock acts as a secondary filter lowering the amount of dust that escapes the bag. Dust socks are to be used in dry and dusty conditions ONLY. Using the dust sock in damp or wet conditions may damage the dust sock and decrease the effectiveness of the filter.
Page 8
QVSP Operator’s Manual ERIODIC AINTENANCE Periodic maintenance should be performed at the following intervals: Maintenance Operation Every Use (daily) Every 5 hrs (daily) Every 10 Hrs Every 25 Hrs Every 50 Hrs Inspect for loose, worn or damaged parts. Clean Debris bag Check Tire pressure Engine (See Engine Manual) Check for excessive vibration...
QVSP Operator’s Manual DRIVE CABLE ADJUSTMENT 1. Disconnect spark plug wire. 2. Remove the bag (item 5) and transmission cover (item 21) which will allow the transmission drive lever arms to be visible. 3. Loosen the two nuts on the barrel of the cable going into the drive levers. 4.
Page 10
QVSP Operator’s Manual PARTS DRAWING QV TO THROTTLE CONTROL CONTROL LEVERS 23 22 Part No 831500 Form No F052912A...
Page 12
QVSP Operator’s Manual PARTS DRAWING QV 67 33 76 77 TRANSMISSION ENGINE TRANSMISSION 45 49 Part No 831500 Form No F052912A...
Page 13
QVSP Operator’s Manual PARTS LIST QV550HSP QV900HSP ITEM DESCRIPTION PART NO. PART NO. HOUSING QV WA W/LABELS 831600 831600 BAG QV 831225 831225 HOOD QVSP W/LABELS 831603 831603 NOZZLE 32" 831606 831606 CASTER SWIVEL QV 831201 831201 ENGINE BASE 5 HP WA SP...