Table of Contents
Advertisement
Installation
2.5 Installing on the S7-1500 standard rail
Dismantling
1. Disconnect all connected cables.
2. Using a screwdriver, pull down the catch on the rear of the device.
3. Remove the device from the standard rail.
2.5
Installing on the S7-1500 standard rail
Requirement
There is a SIM card for the device.
Installation
1. Insert the SIM card, see section "SIM card (Page 27)".
2. Place the first housing guide of the device on the top edge of the standard rail
3. Using a screwdriver, pull down the catch
4. Swing the device down while pulling down the catch
catch locks in place.
5. Connect the power supply, refer to the section "Power supply (Page 28)".
6. Fit the connectors for the digital input and digital output, refer to the section "Digital
input/output (Page 30)".
22
②
on the rear of the device.
③
. After it is released, the spring
Operating Instructions, 10/2016, RC1260-EN-02
①
.
RUGGEDCOM RM1224
Advertisement
Table of Contents
