7. Connect the antenna, refer to the section "Antennas (Page 32)".
8. Connect the device to the local network, refer to the section "Ethernet port (Page 35)".
9. Connect the terminal with as short a cable as possible ≤ 150 mm and a large cross-
sectional area ≥ 2.5 mm² to the ground of the system, see section "Grounding (Page 29)"
Dismantling
1. Disconnect all connected cables.
2. Using a screwdriver, pull down the catch on the rear of the device.
3. Remove the device from the standard rail.
RUGGEDCOM RM1224
Operating Instructions, 10/2016, RC1260-EN-02
2.5 Installing on the S7-1500 standard rail
Installation
23