Enttec DATAGATE MK2 Quick Start Manual page 6

Must have all input sources and output sources
connected
Switcher 2-1:
Controllable Switch operator, acts as a
normal Input A to Output Action, but when the trigger
value is greater than the set Switch it does Input B to
Output Action
Must have all input sources and output sources
connected.
Compressor proportinally reduces all channels of the
input accroding to the value on the control channel.
For example: if control value input is 127 all the values
on the input will be reduced to 50% at output.
This OSC module will allow control from an OSC
controller on port 8000.
IP address: un-used (reserved for future use)
Make sure the App sends to Datagate's IP address
The first 128 DMX channels are mapped to OSC tag:
/dgmk2/x where x is the channel (specified as 0-127)
In each OSC message, there is another argument to
convey level which is a float between 0 and 255.
Examples:
/dgmk2/4 220 : sends value 220 on 5th DMX
•
channel
• /dgmk2/127 125 : sends value 125 on 128th DMX
channel
Limitation: Only one OSC module allowed in the profile
Use exported D-PRO show files as DMX Source
(1 Universe only)
This module
OSC App should send commands to Datagate Mk2 IP
address @ port 8000)
D-PRO supported OSC tags:
/dpro/gm : for Grand Master
/dpro/cuelist/x/command/go :
number x
/dpro/cuelist/x/command/pause : for stop on cuelist
number x
/dpro/cuelist/x/level : for level adjsutment on cuelist
number x
Quick Start Manual
MANUAL-DATAGATE
for more information, visit:
www.enttec.com/datagate
supports OSC
for GO on cuelist
6