Fujitsu ARGA18FMTA Design & Technical Manual page 103

11-3. Function settings on wired remote controller
By using some components on the wired remote controller, you can change the function settings
related on the remote controller.
 Component location
Components on the wired remote controller used for the function settings are located as shown
in the following figure.
NOTE: Do not use DIP switch 2.
 DIP switch setting
By switching each slide switch on the DIP switch 1, you can change the function settings for the
remote controller.
DIP switch 1
*: Switches are fixed at OFF initially.
• SW6: Memory backup setting
Set to ON to use the batteries for memory backup. If the batteries are not used, all of the settings
stored in the memory will be deleted if there is power failure.
NOTE: In case of simple remote controller, do not turn it on.
SW6
OFF
ON
Front case (back side)
DIP switch 2 DIP switch 1
(All switches are fixed at OFF.)
SW1
SW2
SW3
SW4
SW5
SW6
Memory backup
- 48 -
OFF ON
1
2
3
4
5
6
ON
Setting change prohibited*
Setting change prohibited*
Setting change prohibited*
Setting change prohibited*
Setting change prohibited*
Memory backup setting
Disabled
Enabled
Factory setting
♦