REMEHA Quinta Pro 30 Manual page 26

iSense Pro Controller Kit Options
The options illustrated show the four types of controls available. The difference
with the first three kits depends on which type of internal sensor/control is used.
KT1089: the basic internal sensor, no adjustment is available
KT1090: the inside sensor can be used to adjust the room temperature
KT1091: includes a digital remote control which not only acts as a sensor but changes can
be made to the main controller which includes set point temperatures and it can also override
the time settings on both heating and hot water
KT1154: can be used as a boiler sequencer. Will require a 0 - 10v input from a remote
BMS controller
KT1152: required when using more than two boilers (one kit per added boiler up to eight boilers)
e.g. six boilers will require four KT1152
Fitting and user instructions are supplied complete with the iSense Pro kits. The controller is
suitable for 2 - 8 boilers and will time control two zones (optimising and compensating) and
also control temperature and time hot water (note hws control is via a sensor not a thermostat).
Note: The OT cable between the iSense controller and the first boiler is not supplied.
Cable should be 2 core .7mm² (screened when running with higher voltage cables)
iSense Pro Component Details
iSense Pro controller complete with wall box AD283 - Part No. 100018256
Room Sensor Basic AD244 - Part No. 100012044
Room Sensor Temperature Control AD278 - Part No. 100017732
Digtal Remote Room Control AD - Part No. 100013478
Open Therm Interface AD287 - Part No. 100018921
Strap on Temperature Sensor AD199 - Part No. 88017017
Outside Sensor AF60 - Part No. 95362450
DHW Sensor KVT60 - Part No. 95362448
Bus Cable AD134 - 12 metre cable - Part No 88017851
Bus Cable AD124 - 1.5 metre cable - Part No.88017836
The following accessories are not yet available for the iSense Pro.
Please contact our sales or technical departments for further information.
Digital Wireless Remote Control AD256 - Part No.100013475
Wireless Outside Sensor AD251 - Part No.100013306
Wireless Receiver AD252 - Part No.100013307
(must be used if AD256 and AD251 is used)
Note: The above kits and controls will also be suitable for the floor standing Gas 110
Boilers with the exception of the Quinta Pro Open Therm interface (AD287). This will
be replaced by the Open Therm interface AD286 Part No.100018920. This interface
fits external to the boiler.
26