Ametek ABCE702-11R Manual page 21

Reference the below UPM fault code chart to identify the status of the UPM.
UPM Status Code
IF
BE
HL
LL
DB
FF
SF
NOTE:
• If the UPM is on continuously, it will perform an auto battery test every
six days.
• If you are utilizing MopUPS Pro software, you can configure the sys-
tem to automatically self-test periodically.
• The UPM is shipped with a charged battery, but some discharge
naturally occurs during storage and shipment. You may use the UPM
immediately, but you should realize that backup time may be less than
the stated rating until the UPM battery has had at least six hours to
charge.
• We recommend that you do not plug laser printers into the UPM. Laser
printers are known to draw large amounts of current when the fuser/
heater assembly is energized. Laser printers can easily overload the
UPM or create a low voltage condition that can interfere with the oper-
ation of the Voltage Manager circuit.
Rear Panel - Rack mount
A01-00104 Rev A
Definition
Inverter fault
Back-Feed fault
Unit is off due to a high line
Unit is off due to a low line
Unit is off due to a low battery
Fan fault
Site wiring fault
ON
OFF
1 2 3 4
POWERVAR Inc.
Rev.1
4/10/17
PH
Page 1
21