96 Electrical installation
Routing the control cables inside R11 cabinet
1. Stop the drive and do the steps in section
before you start the work.
1. Open the cabinet door.
2. If there is a mounting plate/two plates above the fan, loosen the four screws of the
plate and pull out the plate/s. Unplug the connectors and remove the plate/s.
If there is no mounting plate/s, but instead a shroud/s above the fan, undo the four
screws and remove the shroud/s.
3. Remove the "door" fan (see section
4. The connection terminals are at the left-hand side of the cabinet.
See also page 38.
2
2
3
Electrical safety precautions
Replacing the cabinet "door" fan
4
(page 16)
on page 136).