Table of Contents
Advertisement
Model W1825 (For Machines Mfd. Since 07/15)
Unpacking
This machine has been carefully packaged for safe
transportation. If you notice the machine has been
damaged during shipping, please contact your authorized
Shop Fox dealer immediately.
Inventory
The following is a description of the main components
shipped with the Model W1825. Lay the components out
to inventory them.
Crate.Contents.(Figure.3):.
A. Miter Gauge ............................................... 1
B. Table .........................................................1
C. Back Square Tube ..........................................1
D. Front Rail ...................................................1
E. Sliding Plate ................................................1
F. Guide Post Handwheel ....................................1
G. Table Tilt Handwheel .....................................1
H. Fence Assembly ............................................1
I.
Resaw Fence................................................1
J.
Foot Brake (Pre-Installed/not shown) ..................1
Hardware.and.Tools.(not.shown):.
•
Eye Bolt M10-1.5 (may be installed) ...................1
•
Flat Washers 8mm (Table, Sliding Plate, Fence) .....7
•
Lock Washers 8mm (Table) ...............................4
•
Hex Bolts M8-1.25 x 25 (Table) ..........................4
•
Hex Bolt M8-1.25 x 55 (Sliding Plate) ..................1
•
Lock Nut M8-1.25 (Sliding Plate) ........................1
•
Cap Screws M6-1 x 12 (Sliding Plate) ..................2
•
Hex Bolt M8-1.25 x 90 (Pos. Stop) ......................1
•
Hex Nuts M8-1.25 (Pos. Stop, Fence) ..................2
•
Table Pin ....................................................1
•
Table Insert .................................................1
•
Cap Screws M6-1 x 16 (Fence)...........................2
•
Hex Bolts M6-1 x 20 (Fence) .............................2
•
Fence Handle M8-1.25 x 22 (Fence) ....................1
•
Rail Pad M6-1 x 20 (Fence) ..............................1
•
Hex Nut M6-1 (Fence).....................................1
•
Lock Handle M8-1.25 x 44 (Fence) .....................1
•
Moving Plate (Fence) .....................................1
•
Lock Washers 6mm (Fence, Sliding Plate) .............4
•
Flat Washers 6mm (Fence, Sliding Plate) ..............4
•
Hex Wrench 5mm & 8mm ...........................1 Ea.
•
Open End Wrench 10 x 13mm ...........................1
SETUP
Keep. machine. disconnected. from.
power.until.instructed.otherwise.
Qty
Qty
Figure.3. W1825 inventory components.
If. you. can't. find. an. item. on. this. list,.
check. the. mounting. location. on. the.
machine. or. examine. the. packaging.
materials. carefully.. Occasionally. we.
pre-install.certain.components.for.safer.
shipping.
-11-
A
B
C
G
D
E
F
I
H
Advertisement
Table of Contents
