Response Frame - Omron E5AN User Manual

J Response frame
End
Name
code
10 Parity error
11 Framing error
12 Overrun error
13 FCS error
IC* Undefined error
14 Format error
0D Non-executable command · The set value was written when the "communications writ-
15 Undefined data value
00 Normal completion
* The response format for an "undefined error" differs from the regular response format in that an error code not an "end code" is
stored to the "header code."
J Communications data
Communications
specifications
Sysway
Header
Commu-
nications
code
unit No.
@
The sum total of bits whose received data is "1" does not
match the set value of "communications parity."
Stop bit is "0".
An attempt was made to transfer new data when the recep-
tion data was already full.
The calculated FCS value is different from the received FCS
value.
The header code of the command cannot be interpreted.
· The command length is incorrect.
ing" parameter was set to "OFF" (disabled).
· The set value was written during AT execution.
· The write data is either outside the setting range or not a
numerical value.
· The data is either outside the setting range or not a numeri-
cal value.
The command ended normally without error.
Response format in the case of an undefined error
Header
Commu-
nications
code
unit No.
@
I C
Set (monitor)
Value
Four digits If the uppermost digit is "-1", the
(decimal)
uppermost digit is set to "A".
Example) -1999 ! A999
If the uppermost digit is "-", the
uppermost digit is set to "F".
Example) -10 ! F010
End Text
code
Description
FCS
Termi-
nator
CR
*
Minus Value
4.1 Data Format
FCS Termi-
nator
CR
*
Priority
1
2
3
4
5
6
7
8
—
Decimal Point
The decimal point is removed.
Example) 105.0 ! 1050
4--3