Table of Contents
Advertisement
Installation
Replacing the power supply lead
If the supply cord or plug is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person in
order to avoid hazard.
Opening the terminal board
· Open the back cover of the oven at the bottom (using a flat-
bladed screwdriver) and completely unscrew the connection
screw and the cable clamp before fitting conducting wires into
the appropriate terminals.
To install the cable
· For operation on 220-240V use a type H05VV-F, Min 1.1m,
3X2.5mm² cable.
· Remove the wire clamp screw and the three contact screws
L - N -
· The earth wire (yellow-green) must be at least 20mm longer
than the other wires at the end for connection to the appliance.
· Fasten the wires beneath the screw heads using the following
color scheme : Blue (N) Brown (L) Yellow-Green (
· Fasten the supply cable in place with the clamp and close the
cover of the terminal board.
Earth wire
(yellow-green)
)
46
Hide quick links:
Advertisement
Table of Contents
