Preparing The Pool: Adding Salt; Use; Eixpert User Interface; Setting The Clock - Zodiac EIXPERT Owner's Manual

Preparing the pool: Adding salt

Add refined pool salt (sodium chloride) at the rate of 4 kg per 1000 litres.
This proportion is equivalent to 4,000 ppm (parts per million). The salt should be added at various positions
into the shallow end of the pool. The salt will spread and dissolve more quickly as it runs down the slope of the
pool towards the deep end. Run pump to mix dissolved salt throughout pool. When all the salt has dissolved,
set the chlorine output control to maximum for the first few days monitor your chlorine readings and adjust
as required.
Note: Remove the automatic pool cleaner before adding salt or other chemicals.
Note that the chlorinator output depends on salt concentration, water temperature, and mains power voltage.
The nominal standard values of 4,000ppm salt, 25 degrees Celsius water temperature, and correct mains
voltage, will provide maximum output. If any one or more of these three variables are less than the standard
values, the output may be decreased.

Use

EiXpert user interface

Back
Note: Low mode will stay in operation until deactivated

Setting the clock

The EiXpert chlorinator is fitted with an internal memory and is fitted with battery back up that will
maintain memory for several weeks in the event of a power failure. The time is displayed in a 24 hour
format.
• Switch on the device and wait until screen start-up sequence is finished.
Back
Back Back
Boost
Back
Back
Low
Boost
Boost
Select
Low
Back
Low
Boost
Back
Back
Back
Low
Boost
- Exit the user menu.
Select
- Deactivate Boost mode or Low mode.
Boost
Boost
Low
- From the home screen: increase or decrease in
chlorine production.
Select
Select
- In the user menu: value changes when a choice is
Boost
proposed (flashing characters).
Low
Low
- Access to user menu and navigation in the settings
Select
Select
(with successive presses)
Low
- Activate/deactivate the chlorine production by a
short press.
- Switch off the device with a long press
- Switch on the device with a short press
Select
- Press buttons together to activate Boost
Boost
mode manually
Select
Boost
Select
- Press buttons together to activate "Low"
Low
Select
mode manually
Low
5