Chlorine Production Activated; “Boost” Mode: Chlorine Production Increased To 100 % For 24 H; Manual Activation; Maintenance - Zodiac EIXPERT Owner's Manual

Back
Boost
• Use the and
Back
Select
Back
Boost
• Use the and
Low
Back
Select
• Repeat the steps for Timer 2.
Low
Back
• Press the button to store the timers and move to setting the chlorine production rate.
Back
Boost
• Use the
and
Back Select

Chlorine production activated

Low
When chlorine production starts, the "Start..." message is displayed on screen for about 6 seconds.
"CHLORINATION" is then displayed, indicating that the device is producing chlorine.
"Boost" mode: chlorine production increased to 100 % for 24 h
In certain cases the pool may need higher than normal chlorination (stormy weather, high number of bathers,
Boost
etc.). "Boost" mode is used to increase chlorine level quickly.
Back Select
• Press buttons and
Back
starts.
Low
• To stop "Boost" mode, press
When "Boost" mode is activated, the rated chlorine production settings are temporarily overridden and
the EiXpert chlorinator will operate for a total of 24 hours at 100 % chlorine production.
"Low" mode: chlorine production reduced to 10 % if the pool is covered
If the pool has a covering system (shelter, pool blanket, cover, etc.), "Low" mode is designed to adapt the
chlorine production to situations where the pool is covered. Its effect is to limit chlorine production to 10%.
Boost

Manual activation:

Back
Back
• Press buttons
reduced to 10 %.
Low
• To stop "Low" mode, press

Maintenance

Cleaning the electrode
Although the EiXpert is equipped with reverse polarity technology it is still necessary to check the cell
and if required clean off any build up that may occasionally occur.
• Turn off the chlorinator and the filtration system, close the isolation valves (if applicable), and disconnect the
cell power cable.
• Remove the cell and use a cell cleaning solution* cover all the electrode cell plates.
Boost
Select
Boost
buttons to set the Timer 1 start minutes, then press
Low
Select
buttons to set the Timer 1 start hours, then press
Boost Low
Boost
Select
Select
Low
buttons to choose the required chlorine production rate (from 10 % to 100 %).
Low
Boost
simultaneously: "BOOST" is displayed on the screen and 100 % chlorine production
Boost
Select
Low
Back
.
Boost
Select
Select
and simultaneously: "LOW" is displayed on the screen and chlorine production is
Low Boost
Back
.
Low
Back
Back
Select
Low
Select
Boost
Boost
Select
to store.
Select
Low
to store.
Low
7