Entering Alarm Time (24-Hour Mode) - LG LST-260 User Manual

LGE CDMA Fixed Wireless Terminal
LST-260

Entering Alarm Time (24-hour Mode)

1. Press "#" + "#" + "4" continuously to enter alarm time programming mode.
2. Press "#" and alarm time code "2" for 24-hour mode.
3. Press "#" and alarm time (HHMM). (0000~2359)
4. Press "*" to save and enable Alarm Time.
Disable Alarm Feature
1. Press "#" + "#" + "4" continuously to enter alarm time programming mode.
2. Press "#" and alarm disable code "2".
3. Press "*" to save.
Note :
If Alarm is disabled and time has been already programmed, you can make enable Alarm feature
by pressing "#" + "#" + "4" + "#" + "1" + "*" without entering alarm time again.
5.5 Volume Level
There are three voice volume levels to be controlled by software, and you can set the level to the
adequate conversation volume.
Changing the Volume Level
1. Press "#" + "#" + "5" continuously to enter Volume Level programming mode.
2. Press "#" and Volume Level (1~3).
"1" – LOW Level
"2" – MIDDLE Level
"3" – HIGH Level
3. Press "*" to save.
Before pressing "*", you can enter volume level continuously.
5.6 Outgoing Call Lock
If you try to make an outgoing call while outgoing call lock is enabled, then you will hear warning
tone after dial time-out as an indication of entering the LOCK code. You should enter LOCK code
to make an outgoing call. LOCK code is composed of 4 digits. Outgoing Call Lock feature is
disabled as a factory setting.
Enable or Disable Outgoing Call Lock
1. Press "#" + "#" + "6"+ continuously to enter Outgoing Call Lock programming mode
2. Press "#" and "LOCK code (4 digits)"
3. Press "#" and Enable ("1") or Disable ("2") code.
4. Press "*" to save.
25