Table of Contents
Advertisement
LGE CDMA Fixed Wireless Terminal
LST-260
3
.
B
a
s
i
c
O
p
3
.
B
a
s
i
c
O
p
3.1 Power On
1. The POWER LED indicates the presents status;
1)
Using AC Adapter : Solid GREEN
2)
Using internal battery : Solid RED
3)
Using internal battery and battery is weak capacity: Solid ORANGE
2.
When the terminal succeeded in getting the service, SIGNAL LED indicates the strength of
the signal(Table 1).
Lifting handset on telephone, dial tone is heard and you can enter a phone number.
Note :
*) Not entering any key for 15 seconds warning tone will be produced.
*) In the overlap dial mode, it may take over 15seconds.
*) If Hot Line function is enabled, busy tone is not produced and hot line number is
automatically connected.
*) While having maintenance request order or lock order from the system, neither dial tone nor
busy tone is produced. Instead of them, the lock tone("pi-pi-pi") will be heard one time and
there will be no sound and ALL LED's will be blinking with GREEN color simultaneously
3. If the radio service is not available or radio signal is too weak to detect;
The SIGNAL LED is RED. (No Service status)
.
3.2 Placing a call
When lifting handset of the connected telephone ("off hook"), the terminal determines whether
cellular service is available.
If it is available, dial tone is produced and a number can be dialed normally.
If phone service is not available, SIGNAL LED of the terminal will be RED and no dial tone will
be heard.
If user press '#' button after dialed the number, the terminal make a call immediately.
3.3 Receiving a call
The connected telephone rings when an incoming call is detected.
Pick up the handset and begin talking.
3.4 Ending a call
When you have completed the call, place the handset back on telephone. Also you can hook
e
r
a
t
i
o
n
e
r
a
t
i
o
n
18
Advertisement
Table of Contents
