Cleaning - Blaupunkt 5B47M80 Series Instruction Manual

Changing the basic settings
The function selector must be set to the "Off" position.
Touch and hold the r button for approx. 4 seconds.
1.
The first basic setting will appear on the display
panel, e.g. ™‚ ‚.
Use the ~ or } button to change the setting if
2.
necessary.
Touch the r button to confirm.
3.
The next basic setting will appear on the display
panel.
Touch the r button repeatedly to call up all the
4.
basic settings. To change these settings, touch the
~ or } button.
Finally, touch and hold the r button again for
5.
approx. 4 seconds to confirm that you want to use
the settings you have selected.
This applies all the basic settings.
You can change the basic settings again at any time.
Note: Your changes to the basic settings will be
retained even after a power failure.
DCleaning
W ith good care and cleaning, your appliance will retain
C l e a n i n g
its appearance and remain fully functioning for a long
time to come. We will explain here how you should
correctly care for and clean your appliance.
Suitable cleaning agents
To ensure that the different surfaces are not damaged
by using the wrong cleaning agent, observe the
information in the table. Depending on the appliance
model, not all of the areas listed may be on/in your
appliance.
Caution!
Risk of surface damage
Do not use:
Harsh or abrasive cleaning agents,
■
Cleaning agents with a high alcohol content,
■
Hard scouring pads or cleaning sponges,
■
High-pressure cleaners or steam cleaners,
■
Special cleaners for cleaning the appliance while it is
■
hot.
Wash new sponge cloths thoroughly before use.
Tip: Highly recommended cleaning and care products
can be purchased through the after-sales service.
Observe the respective manufacturer's instructions.
:
Warning – Risk of burns!
The appliance becomes very hot. Never touch the
interior surfaces of the cooking compartment or the
heating elements. Always allow the appliance to cool
down. Keep children at a safe distance.
Area

Cleaning

Appliance exterior
Stainless steel Hot soapy water:
front Clean with a dish cloth and then dry with a soft
cloth.
Remove flecks of limescale, grease, starch and
albumin (e.g. egg white) immediately. Corrosion
can form under such flecks.
Special stainless steel cleaning products suitable
for hot surfaces are available from our after-sales
service or from specialist retailers. Apply a very
thin layer of the cleaning product with a soft cloth.
Plastic Hot soapy water:
Clean with a dish cloth and then dry with a soft
cloth.
Do not use glass cleaner or a glass scraper.
Painted surfaces Hot soapy water:
Clean with a dish cloth and then dry with a soft
cloth.
Control panel Hot soapy water:
Clean with a dish cloth and then dry with a soft
cloth.
Do not use glass cleaner or a glass scraper.
Cleaning
en
17