Cleaning The Self-Cleaning Surfaces In The Oven; Detaching And Refitting The Rails - Blaupunkt 5BD324.1 Installation Manual

Wipe with a damp cloth. Dry with a soft cloth.
Seal
Warm soapy water or a vinegar solution. If
Oven floor
there are heavy deposits of dirt, only use oven
cleaner on cooled surfaces.
Wipe with warm soapy water and a cloth. Dry
Glass cover
with a soft cloth.
for the oven
light
Soak in warm soapy water. Clean with a brush
Accessories
or sponge.
Do not clean in the dishwasher. Never use
Aluminium
oven cleaner. To prevent scratches, never
baking tray
touch the metal surfaces with a knife or a sim-
(optional)
ilar sharp object. Clean horizontally with some
washing-up liquid and a damp glass cleaning
cloth or a microfibre cloth – do not press too
hard. Dry with a soft cloth. Do not use any
abrasive materials, scouring sponges or
rough cleaning cloths. Otherwise, you may
scratch the surface.
If a childproof lock has been fitted on the
Childproof
oven door, it must be removed before clean-
lock (optional)
ing. Soak all plastic parts in warm soapy
water and clean with a sponge. Dry with a soft
cloth. If it is very dirty, the childproof lock will
not work properly.
Refer to the hob instruction manual for infor-
Hob
mation about care and cleaning.
Cleaning the self-cleaning surfaces in the
oven
The back wall, roof and side walls of the oven are coated with
self-cleaning enamel. This coating absorbs and dispels
splashes from baking and roasting while the oven is in
operation. You will obtain a better result, the higher the
temperature and the longer the oven is in operation.
If the oven is still dirty even after repeated use, proceed as
follows:
First clean the oven floor.
1.
Then set › 3D hot air or
2.
Heat the empty oven for approx. 2 hours at maximum
3.
temperature.
The ceramic coating is regenerated. Brown and white residue
can then be removed with water and a soft sponge.
Slight colour variations of the coating have no effect on the self-
cleaning function.
Caution!
Never use abrasive cleaners. This could scratch or damage
■
the highly porous surface coating.
Do not use oven cleaner on self-cleaning surfaces. If oven
■
cleaner is accidentally applied to these surfaces, wipe it away
immediately with a sponge and plenty of water.

Detaching and refitting the rails

The rails can be removed for cleaning. The oven must have
cooled down.
Unhooking the rails
Hold the shelf frames from underneath and pull slightly
1.
forward. Pull the extension pins at the bottom of the rails out
of the mounting holes (Fig. A).
% Top/bottom heating.
Then fold the rails upwards and carefully remove them
2.
(Fig. B).
Clean the rails with washing-up liquid and a sponge. For
stubborn deposits of dirt, use a brush.
Installing the frames
Insert the two hooks carefully into the upper holes. (Figure A-
1.
B)
:
Incorrect assembly!
Never move the frame before the two hooks are fully
anchored in the upper holes. The enamel could be damaged
and may break (figure C).
the two hooks must be inserted fully into the upper holes.
2.
Now move the frame slowly and carefully downwards and
insert in the lower holes (figure D).
Insert both frames into the side walls of the oven (figure E).
3.
If the rails are fitted correctly, the distance between the two
upper shelf positions is greater.
51