Stanley IBC600 User Manual page 9

2
CRIMPING
1. Set the Trigger Lock
Set the trigger lock BEFORE attaching
dies to the jaw!
2. Clip the die onto the Crimping Jaw.
DO NOT crimp live cables! IBC600 is
NOT a live-line tool!
3. Release the Trigger Lock.
4. Press and hold the trigger until the tool has finished.
InteLED System
The InteLED system shows the status of the crimp. The light ring will shine different colors depending on the status
of the crimp.
InteLED Light Ring
OPERATION
4 5
1
5. Press and hold the pressure release.
Note: Release the trigger to immediately stop the
tool. Press the pressure release at any time to open
the jaws.
Figure 1: Lock the Trigger
InteLED
Crimping. InteLED will stay
White lit for 30 seconds after a
crimp is complete.
Green The crimp is good.
IBC600 did not reach full
Red
pressure. Crimp again.
IBC600 User Manual ◄ 9
Meaning