Factory Reset - Bush 487/6474 Instruction Manual

Using your Outdoor DAB Radio
Let's get started
With your radio switched on (not in Standby mode):
1. Press and hold the Menu/Info button to enter the menu options.
2. Use the Tune control to scroll to <System>. Press and release the Enter button.
3. Use the Tune control to scroll to <SW Version>. Press and release the Enter button.
The software version will be displayed and you may wish to make a note of it here:
...................................................................................

Factory reset

You can reset your radio and restore all of the original factory settings.
Note: If you reset your radio all of your stored station presets will be deleted.
With your radio switched on (not in Standby mode):
1. Press and hold the Menu/Info button to enter the menu options.
2. Use the Tune control to scroll to <System>. Press and release the Enter button.
3. Use the Tune control to scroll to <Factory reset>. Press and release the Enter button.
Factory Reset? <No> Yes will be displayed.
4. Use the Tune control to scroll to <Yes>. Press and release the Enter button.
5. Restarting... will be displayed. After a few seconds the display will change to Welcome
to Digital Radio and will then go to Standby mode. When you next power on your
radio from Standby mode, it will begin an automatic scan for DAB stations. A progress
bar will show the progress of the scan and the number of stations found during
the scan will also be displayed. When the scan is complete your radio will select
the first available station and begin to play. Stations are listed in numerical and then
alphabetical order by default.
section of these instructions, or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 600 3021.
Using your Outdoor DAB Radio
35