Table of Contents
Advertisement
Other information
Helpful technical information
Software version
You can check the software version of your radio.
With your radio switched on (not in Standby mode):
1. Long press the Menu button to enter the menu options.
2. Short press the Prev button to scroll to <System>. Short press the Select button.
3. Use the Prev or Next button to scroll to <SW Version>. Short press the Select button.
The software version will be displayed.
Factory reset
You can reset your radio and restore all of the original factory settings.
Note: If you reset your radio all of your stored station presets and the radio station list
will be deleted.
With your radio switched on (not in Standby mode):
1. Long press the Menu button to enter the menu options.
2. Short press the Prev button to scroll to <System>. Short press the Select button.
3. Use the Prev or Next button to scroll to <Factory Reset>. Short press the Select button.
Factory Reset? Yes <No> will be displayed.
4. Short press the Prev button to scroll to <Yes>. Short press the Select button.
Restarting... will be displayed. After a few seconds your radio will begin an automatic
scan for DAB stations. A progress bar will show the progress of the scan and the
number of stations found during the scan will also be displayed. When the scan is
complete your radio will select the first available station and begin to play. Stations are
listed in numerical and then alphabetical order by default.
36
Other information
Other information
Helpful technical information
Technical specification
Power adaptor:
Output DC 5V 1A
Input AC 100-240V, 50/60Hz
Audio output:
1 x 1W RMS
Frequency range:
DAB:
Band III, 174 MHz to 240 MHz
FM:
87.5 MHz to 108 MHz
section of these instructions, or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 600 3021.
37
Other information
Advertisement
Table of Contents
