About The Printer's Power; Installing & Removing The Battery - Avery Dennison Monarch SIERRA SPORT4 9493 Operator's Handbook Manual

A b o u t t h e P r i n t e r ' s P o w e r
There are two ways to power the printer:
♦ Using a battery. See "Installing and Removing the Battery" for more information.
♦ Using the AC power adapter. Refer to the 9496™ Operating Instructions included with the
charger/adapter for more information.
I n s t a l l i n g & R e m o v i n g t h e B a t t e r y
You must charge the battery before using it for the first time.
To install the battery:
1. Review the safety information in the Regulatory Compliance document included with your
printer.
2. Turn off the printer when you change batteries.
3. Lay the printer down so the back of the printer faces up.
4. Remove the plastic from a new battery.
5. Slide the battery into the battery well in the bottom of the printer until it latches into place.
6. Set the printer upright.
7. Turn on the printer by pressing P.
The display flashes printer version information and battery charging status, then you see
To remove the battery:
1. Turn off the printer.
2. Lay the printer down so the back of the printer faces up.
3. Press the latch down with your thumb and slide the battery out of the battery well.
1-2 Operator's Handbook
Latch