Assembly - ProForm PFEL03907.0 User Manual

ASSEMBLY

To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480.
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included hex keys
adjustable wrench
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses
below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number
following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre-
assembled. If a part is not in the parts bag, check to see if it has been pre-assembled.
M6 Nylon Wave Washer
Locknut (77)–4
M4 x 12mm
Screw (99)–4
M6 x 16mm Patch
Screw (80)–6
, and rubber mallet
M10 Split
(88)–2
Washer (78)–10
M4 x 16mm
Screw (84)–10
M6 x 36mm Button
Bolt (76)–4
and your own Phillips screwdriver
.
M10 x 20mm Patch
Screw (79)–4
M4 x 16mm
Round Head
Screw (94)–4
M10 x 70mm Button Screw (75)–6
5
,
M10 x 35mm Shoulder
Screw (63)–2
M4 x 32mm Screw
(95)–2