Smoke Detector - Holiday Admiral 2016 Manual

6. Measure the height from the ground
to the center of the low beam filament
of the driver's side headlamp. Project
this height in an exact straight line
to the vertical surface 7.62 m away
from the motorhome. Mark the height
of the filament and center line on the
vertical surface. This will have set up
a "coordinate system" for protecting
the headlamp's beam on the vertical
surface.
7. Repeat step 6 for the passenger's side
headlamp.
8. Turn on the headlights. Using Figure
1 below, the projected beam on the
vertical surface is to be located as
follows.
A - Type 1 Headlamps: The projected
beam should be centered vertically
and horizontally on the vertical
surface as marked in step 6 and 7.
B - Type 2 Headlamps: The top edge
of the projected beam is to be even
with a horizontal line parallel to a
line formed by the two headlamp
filament centers and to the right
of the vertical center line of each
headlamp.
9. If the headlamps do not meet
the alignment criteria adjust the
"Vertical" and/or "Horizontal"
positioning as shown on the attached
figure. Rotate the adjustment knobs
and/or screws on the headlamp.
When turning the knobs and/or
screws, watch the direction in which
the projected beam moves to help
understand which direction on the
beam moves in relation to turning
each.
10. Remember, this procedure is only
a guideline and is not a substitute
for having headlamps professionally
aligned.

sMOkE dETEcTOR

Statistics show that most fire casualties are
not caused by direct flame, but by less visible
smoke (products of combustion). The smoke
detector automatically returns from alarm to
normal state when the reason for activation,
the presence of smoke, is completely removed.
Reduce risk of fire by being safety conscious.
Located on ceiling
WARNING:
There is no way to ensure against
injury or loss of life in a fire; however,
the smoke detector is intended to help
reduce the risk of tragedy. Additional
smoke detectors may help to reduce
the risk. Proper use and care of the
smoke detector could save lives.
2016 Admiral
INFORMATION:
Refer to the smoke detector OEM
manual for detailed information and
maintenance information.
Operation
When a 9 Volt DC battery is correctly
connected the LED flashes every minute and
a loud alarm will sound when a production of
combustion is sensed.
NOTE:
The unit will not operate without
a battery. A battery flag will pop
up preventing the unit from being
installed to the mounting bracket
without a battery. Carbon Zinc
batteries average a service life of one
year. Alkaline batteries average a
service life of one to two years.
Testing
Simply press the test button on the smoke
alarm cover for approximately three seconds.
The alarm will sound if all electronic circuitry,
horn and battery are working properly. The
smoke alarm should be tested at least once a
week when the motorhome is in use, prior to
each trip and when the motorhome has been
in storage. When testing the smoke alarm it is
advised to stand at arm's length or muffle the
020123
alarm.
020155e
43